|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
May 20th 04, 06:09 PM
|
|||
|
|||
help choosing pump size
On 19 May 2004 14:34:10 -0700, (mark) wrote:
I am building my first waterfall/pond. The pond is 4'x4'x2' deep. The falls will be only about 3 or 4 feet from the pump and about 4' high. Can anyone recommend the pump size that I need? http://www.pondsonlinecanada.com/hints.htm#WEIRCHART Head is measured from the top of the water to the highest point the water must be pumped. Wier is the width of the waterfall where the water drops. Your pond should be about 240 gallons of water. 4x4x2=32cubic feet. 32 cu. ft = 239.3766 gal Regards, Hal 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Have you ever measured real water pump output flow rate? | Pszemol | Reefs | 26 | January 19th 04 04:33 AM |
| Pond Pump Size Question | Steve Shapson | General | 3 | December 29th 03 08:05 PM |
| Return pump size | [email protected] | Reefs | 1 | September 11th 03 02:34 AM |
| Help choosing a pump for my new pond.... | Ben Raines | General | 8 | July 25th 03 12:41 PM |
Hybrid Mode
