![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
"Pszemol" wrote in message ...
"Timothy Tom" wrote in message om... The reason that it is useful is that when the power goes off, the sump fills with water. When the power returns, the in-sump protein skimmer will overflow onto the cabinet floor a significant amount of water. Well... this sounds like a bad design... What are you going to do if the power outage will last more than 15 minutes? Yes it was not designed well. Custom made tank, stand, protein skimmer made out of state and shipped to me. http://hometown.aol.com/tdtom30/tomsreef.html When the power goes off, water drains into sump. Since the protein skimmer sits in the sump, the water level in the skimmer rises too. When pump restarts and bubbles start rising into the skimmer chamber, water overflows into collection container with a capacity of about a quart. Water overlows collection collector onto cabinet floor. Once level in sump drops, the level in skimmer drops, and overflowing stops. Usually probably about 1/2-1 quart of water leaks. Not a disaster, just a little mess. Cabinet is too small to accommodate a larger collection chamber conveniently. |
#2
|
|||
|
|||
![]()
When the power goes off, water drains into sump.
How are your returns plumbed in? Many people drill a small hole in the return just below the display tanks running water level. That way, once it drains past the hole and hits air, the siphon is broken. The other option is check valves, but they can stick open so you have to clean/check/replace often. Do you have pics of your plumbing? ~John |
#3
|
|||
|
|||
![]() |
Thread Tools | |
Display Modes | |
|
|