![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Hi All,
I was wondering if anyone had ever hooked up an overhanging powerfilter to an undergravel filter? I notice that after I have my tank set up for a while, lots of mulm accumulates under the UGF's bed. (Again, this is expected and wanted). So every other water change I do, I pull out one of the extra cap, put the syphon over the hole and suck out as much of the crap (no pun intended) as I can remove. This works well enough that I don't mind doing it. All that being said, I noticed that my Aquaclear 500 is almost exactly above on of the UGF's tube opening which made me think. Would it be a good idea to link them. The positives I see is that it would remove much mulm from the bottom and since it's constant, it won't have time to build up. The downsides I see are that I have to change the filters more often this way. Does anyone see any other negative or positives about this? And/or has anyone done this before? TIA -Ben |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
juwel filter | Stefano | General | 3 | August 1st 04 04:55 PM |
louder Whisper filter | David Ditch | General | 2 | November 27th 03 04:16 PM |
Filter opinions? | Dan Norgard | General | 7 | September 3rd 03 10:44 PM |
Filter Media | Eddie | General | 12 | September 2nd 03 09:50 PM |
first filter change | Dr Engelbert Buxbaum | General | 0 | July 16th 03 12:00 PM |