![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Went to pick up feed for the goats today and noticed they just got a
shipment of super heavy duty blue poly water tanks for livestock in. Dimensions is 22"deep x 10' diameter. Has a 1 1/2" threaded drain plug on a recess channel on the bottom, and the top lip is really heavy duty and rolled over into a square shaped letter C. The top edge is perhaps a good 3/8" in thickness so it takes up to cattle etc leaning against it. Made by Beehm (Sp?) company. Price is only $146.00........Be a decent sized preformed pond..........but would be even nicer if it was available in black.....but the blue is not bad looking....Oh yea, it also has a 20 year warranty againt sun damage and such, and has UV inhibitors. Visit my website: http://www.frugalmachinist.com Opinions expressed are those of my wife, I had no input whatsoever. Remove "nospam" from email addy. |
#2
|
|||
|
|||
![]()
We have one of those for a hospital tank. I never can get used to the
color. The lip on ours is like that too, but it cracked. To be fair, I think that was from tipping it up on its side to dump out the last of the water that was too low to drain. I actually drilled a hole just under the lip and would manipulate it over some kind of recess or "dog-dug" hole in the ground to get the water out. I love the depth of ours. It's deeper than the one you saw. But, it's not as big in diameter. I'd love to get one as deep as ours, but ten feet across like that one. Besides, like I said, I hate the color. Some kind of good paint is called for here, maybe. You might find something interesting under a thread titled "What kind of paint". I was asking about painting milk crates and some good ones were mentioned. "Roy" wrote in message ... Went to pick up feed for the goats today and noticed they just got a shipment of super heavy duty blue poly water tanks for livestock in. Dimensions is 22"deep x 10' diameter. Has a 1 1/2" threaded drain plug on a recess channel on the bottom, and the top lip is really heavy duty and rolled over into a square shaped letter C. The top edge is perhaps a good 3/8" in thickness so it takes up to cattle etc leaning against it. Made by Beehm (Sp?) company. Price is only $146.00........Be a decent sized preformed pond..........but would be even nicer if it was available in black.....but the blue is not bad looking....Oh yea, it also has a 20 year warranty againt sun damage and such, and has UV inhibitors. Visit my website: http://www.frugalmachinist.com Opinions expressed are those of my wife, I had no input whatsoever. Remove "nospam" from email addy. |
#3
|
|||
|
|||
![]()
On Tue, 28 Sep 2004 18:12:54 GMT, "Ann in Houston"
wrote: ===We have one of those for a hospital tank. I never can get used to the ===color. The lip on ours is like that too, but it cracked. To be fair, I ===think that was from tipping it up on its side to dump out the last of the ===water that was too low to drain. I actually drilled a hole just under the ===lip and would manipulate it over some kind of recess or "dog-dug" hole in ===the ground to get the water out. I love the depth of ours. It's deeper ===than the one you saw. But, it's not as big in diameter. I'd love to get ===one as deep as ours, but ten feet across like that one. Besides, like I ===said, I hate the color. Some kind of good paint is called for here, maybe. ===You might find something interesting under a thread titled "What kind of ===paint". I was asking about painting milk crates and some good ones were ===mentioned. === I should have mentioned it, but didn't. The depth size listed was to a ridge below the lip. The lip is approx 3 or 4 inches higher than the depth from the bottom to this ridge. The ridge is perhaps 1" wide so times that by 2 and overall width by my tape meaure would be 9' 10" and the overallheight wold be better about 26" so you can easily have 22 inches of water or up to say 24" of water in it if you fill it over the first stepped lip. This blue color is, well, not bad, but would nicer if it was darker blue, instead of a sky blue color. It wold probably remind you of a swiming pool with the color it is when filled with water. I seen the ultimate container yesterday on my rounds scrounging up odds and ends. Its a swim in place pool. Overall water depth is 60" and its 10 feet wide by 14 feet long.........has all kinds of jets and also skimmers, and has built in recesses and ledges to hang on for inwater exercising, and 6 built in benches along the sides for use as a hot tub.......Fully enclosed sides made of cedar, and the container is fiberglass. You could actually get in this and swim with the fishes. Biggest draw back is it costs $11,000 delivered plus taxes. I usually stop at local hot tub delaers and pool stores and pickup scrounge items. Yesterday Ipicked up total of 5 Hayward pump/filter baskets........2 small circulaitng pumps for hot tubs, and 2 sand type filter containers with internal plumbing and external valves......Pumps should be fixable, some have motors burned out other have bad pumps, but a little time and fiddling should get a few pumps up and running......Have to go back and pick up one discarded hot tub yet, whichI figure should make a suitable small pond once the holes from the jets etc are sealed up. Nothing a little fiberglass patching wont solve, and the shell removed fromthe enclosure and set into the ground........its an 6-8 person hot tub, and has a rough texture white/creame and tan finish.. Hey if its free its for me! Visit my website: http://www.frugalmachinist.com Opinions expressed are those of my wife, I had no input whatsoever. Remove "nospam" from email addy. |
#4
|
|||
|
|||
![]()
Roy wrote:
would nicer if it was darker blue, instead of a sky blue color. It wold probably remind you of a swiming pool with the color it is when filled with water. How long do you think it would take to look essentially "muddy green", though? I suppose if you _wanted_ it to get all algae covered, it wouldn't... I seen the ultimate container yesterday on my rounds scrounging up odds and ends. Its a swim in place pool. Overall water depth is 60" and its 10 feet wide by 14 feet long.........has all kinds of jets and also skimmers, and has built in recesses and ledges to hang on for inwater exercising, and 6 built in benches along the sides for use as a hot tub.......Fully enclosed sides made of cedar, and the container is fiberglass. You could actually get in this and swim with the fishes. Biggest draw back is it costs $11,000 delivered plus taxes. You can usually find "scratch & dent" versions... I usually stop at local hot tub delaers and pool stores and pickup scrounge items. Yesterday Ipicked up total of 5 Hayward pump/filter baskets........2 small circulaitng pumps for hot tubs, and 2 sand type filter containers with internal plumbing and external but obviously, you know that :-) its an 6-8 person hot tub, and has a rough texture white/creame and tan finish.. Hey if its free its for me! Sounds excellent. -- derek |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Settling Chamber out of 70g stock tank - How to create drain system (for flat bottomed tanks?) | Lisa | General | 9 | June 19th 04 09:24 AM |
Hard-Find-Plants--Latest Shipment | CS | Plants | 1 | February 16th 04 03:43 AM |
Hard-to-Find Plants--Current List | CS | Plants | 1 | February 11th 04 07:48 PM |
PetsMart tanks | TYNK 7 | General | 5 | January 5th 04 04:10 AM |
Moving from MN to TX. Selling all my Tanks and fish, Champlin MN 55316 | Racf | Marketplace | 0 | December 6th 03 08:45 AM |