|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
October 11th 04, 06:19 PM
|
|||
|
|||
"Rob" wrote:
I just installed a copper gate valve and remembered I'd read here that copper is a no-no in ponds because it can kill the fish. What's the opinion he will one short length of copper (actually, it's brass, that has copper in it) cause problems in my 400 gallon pond? I wanted a PVC valve, but it wasn't available at the time of my purchase... I wouldn't worry about it. While copper is dangerous to fish, if you do regular water changes I doubt the levels would be able to build up to anywhere near a toxic level. San Diego Joe 4,000 - 5,000 Gallons. Goldfish, a RES named Colombo and an Oscar. ----== Posted via Newsfeeds.Com - Unlimited-Uncensored-Secure Usenet News==---- http://www.newsfeeds.com The #1 Newsgroup Service in the World! 100,000 Newsgroups ---= East/West-Coast Server Farms - Total Privacy via Encryption =--- 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gang valve after needle valve? | Paulio629 | Plants | 3 | April 13th 04 07:37 PM |
| Question about copper | Marco Qualizza | Reefs | 5 | April 11th 04 08:43 PM |
| Copper Salts & Maintenance | LoveFish | General | 0 | April 10th 04 04:03 AM |
| Safety of Copper Pipes? | BenignVanilla | General | 25 | February 18th 04 04:28 PM |
| Question about Algae and Copper | Robert Mockan | General | 2 | November 16th 03 06:15 PM |
Hybrid Mode
