|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 27th 04, 06:05 PM
|
|||
|
|||
Output adapter for skimmers/filters
A while ago I stumbled upon a web site selling some kind of adapter that would
allow a tube to be connected to a skimmer or filter with a cascading water output, but I can't seem to find it again. Has anybody seen something like that? I can't remember if it was designed for a specific skimmer or filter, or if it was a generic device. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Do I have the right mix of my ATI T5 High Output aquarium bulbs? | Ed Schreibman | Reefs | 1 | April 30th 04 02:43 PM |
| Eheim 2217 output too powerful? | HDH | General | 8 | March 30th 04 10:50 PM |
| Best location for RUGF output? | Dave | General | 3 | March 18th 04 01:29 PM |
| Where to put output of DIY CO2? | Evergreen | Plants | 4 | January 19th 04 09:29 PM |
| No Better RO/DI Anywhere!!! | Pat Hogan | General | 0 | November 14th 03 05:57 PM |
Threaded Mode