|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 11th 03, 01:02 AM
|
|||
|
|||
Question on hooking up a RedSea Berlin
I have a Berlin that I want to use to replace my underpowered Prizm. I
have a MAG5 pump to drive it. The model of Berlin I have has a built in (but removeable) venturi and an air hose with a needle valve. WHen the MAG5 was shipped the supplier also included a Kent Venturi fitting. Do I need to run both? I was planning on just connecting the MAG5 to the Berlin... Help appreciated! 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Air line to Berlin HO from RIO 2500 | Greg | General | 0 | July 10th 04 12:03 AM |
| I need a very simple answer to a lighting and filter question. | Ben | General | 8 | July 26th 03 07:12 AM |
| Question about sand/ crushed coral | Brian McCarty | Reefs | 3 | July 14th 03 03:41 AM |
Threaded Mode