|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
August 8th 03, 03:09 PM
|
|||
|
|||
CF bulb failure mode?
I have a 96 watt CustomSeaLife Smartlight that stopped working. The lamp
will not light at all. The bulb has been in service for 3+ years. Is this a typical bulb failure given the amount of use the bulb has seen? Unfortunately I was not around when it failed. Before I spend $50 on another bulb it would be reasuring to know that fluorescents will fail this way rather than the possibility of my ballast going AWOL. Have other folks had good luck with these fixtures? Thanks for any input. Jeff Dantzler (reply to group rather than email) Seattle, WA 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode