|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
May 16th 06, 04:39 PM
posted to rec.aquaria.freshwater.misc
|
|||
|
|||
NetMax's Tank Stand
NetMax,
About the Base/Stand on your large tank you described from the website--Did You cut the 4x4's (or 6x6) timbers to be flush against the wall or is it pyramiding symmetrically? -- Posted via Opera Nine(Beta2).....Thanks!!-ED http://www.frontiernet.net/~cuttysark These Colors Don't Run. -- Long Live Neil Young -- 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stand ideas for Gill's new 130g | NetMax | General | 4 | January 29th 06 09:01 PM |
| A sad end to my holiday | Gill Passman | General | 27 | August 10th 05 03:23 AM |
| Acrylic tank question | Dan J. S. | General | 17 | February 3rd 04 01:05 AM |
| Applying urethane to particle board tank stand | Harry Muscle | General | 3 | December 23rd 03 02:10 PM |
| penny gap from stand to tank ?? | [email protected] | General | 3 | December 1st 03 04:14 PM |
Hybrid Mode
