![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I picked up a floating hydrometer and I'm wodering if they are affected by
barometric pressure? When I float it in RO water it reads 1.004. Since I'm located in Iowa, which is above sea level a bit, will this affect the reading a bit? As it is, I use 1.004 as a base reading and adjust accordingly. Thanks, Mark |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rec.ponds FAQ | Snooze | General | 0 | May 17th 05 03:05 AM |
Rec.ponds FAQ | Snooze | General | 7 | April 11th 05 07:04 AM |
Fiddler crabs and floating island question. | [email protected] | General | 6 | April 6th 05 03:09 AM |
Question on removing floating grass | RobH | General | 5 | August 2nd 04 10:22 PM |
Hydrometer Question 2-13-04 | Steven Pace | Reefs | 4 | February 17th 04 05:31 PM |