![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Ok everyone I have algea and I'm not ashamed to admit it right now.
Does anyone know if once a plants leaves have a lot of algea covering Yes I am using compressed co2 and it is turned on/off w/ the lights. The lights are on for 9 hours at full strength on 12 total starting the cycle with the 40w strip and ending with it. I will make the change and observe I was told before not to exceed 10. I do have co2 injection. I usually test the ph about two hours before lights out and it always ranges from 7.6 to 7.0 with a kh of 5-6. The dark brown is not removable with fingers so I wouldn't say that it is soft it is more spotted on the leaves but it forms clumps. Its not on everything . How long has your tank been set up and planted? In april I started. My tank was redone on 5/25 with new substrate and I've had problems ever since. I used to have blue/black rock and it wasnt very appealing so with research I changed to about 1- 1 1/2" of flourite and 2" of natural stone(small) I appreciate your reply its hard for me to find people with knowledge. I feel like a lone ranger. Thanks again Matt / |
#2
|
|||
|
|||
![]()
I usually test the ph about two hours before lights out and it always
ranges from 7.6 to 7.0 with a kh of 5-6. That is a *huge* variation. With your KH, your pH should be 6.8-7.0, all day, every day. With your lighting levels, it's essential. You might find it easier to just leave the CO2 on 24/7. After measuring the pH of my tank several times a day for a few days, I found that leaving the CO2 on all the time resulted in a more stable pH than turning it off at night. (Not to mention a head start in the morning when the lights go on.) The dark brown is not removable with fingers so I wouldn't say that it is soft it is more spotted on the leaves but it forms clumps. Its not on everything . Hmm. Can you get a picture? I don't think I've ever seen a dark brown algae that forms clumps. There's a dark blue-green algae that does. In any case, you should add a few algae-eaters to your tank if you don't have any. Otos, the right kind of snails, a bristlenose pleco, something like that. But it might be best to wait until you get your CO2 stable. Some of these animals are rumored to dislike wildly fluctuating pHs. In april I started. My tank was redone on 5/25 with new substrate and I've had problems ever since. I used to have blue/black rock and it wasnt very appealing so with research I changed to about 1- 1 1/2" of flourite and 2" of natural stone(small) Your tank is still new, then. It can take awhile to get a new tank in balance, especially if you're new to planted tanks. Don't give up! The most important thing right now is to get your CO2 levels up and stable. What kind of filters, powerheads, etc., do you have on the tank? With a tank as large and as brightly-lit as yours, it may be hard to keep enough CO2 in the water, even if have a compressed system. See if you can reduce surface turbulence. Also, what kind of reactor or diffuser are you using? If turning up the CO2 and reducing turbulence doesn't work, a more effective diffuser might help. Since your tank and presumably your plants are new, I would definitely cut off old, algae-encrusted leaves. (Not all once -- maybe one or two a day.) It's normal for the leaves of swords to die after a few weeks after you plant them. Swords (and many other aquarium plants) are grown emersed (with the leaves above water). Once you plant them underwater, the emersed leaves die, and are replaced by new, submersed growth that may look quite different. As long as new leaves are appearing, the plant is probably okay. I appreciate your reply its hard for me to find people with knowledge. I feel like a lone ranger. If you haven't found Chuck's page yet, check it out: http://www.csd.net/~cgadd/aqua/index.htm Lots of useful info, especially in the "articles" section. Leigh http://www.fortunecity.com/lavender/halloween/881/ |
#3
|
|||
|
|||
![]() Because you have such a brightly-lit tank, you may need to add more Flourish, etc., than the label says. The best way to do this is to let your plants be your guide. If they look pale, they probably need more fertilizer. It's not uncommon for people to have to add four times as much as the label says, or even more, for a high-tech tank with a lot of plants in it. Each tank is different, so you'll have to experiment to see what works best for you. Should a tank like mine be pearling everday w/ proper fert and co2? Will the change either good or bad be noticed within a few days. So I will know if I am overdosing or underdosing? You should also make sure that a lot of your plants are fast-growing stem plants. Cabomba, Limnophila, Bacopa, Rotala, water sprite, Hygrophila, etc. It's the fast-growing plants that are best at outcompeting the algae. Especially at the beginning, you should have a lot of fast growers. I have some rotala and sunset hygro that Ive had for a month and has already needed triming.The swords and sags are the problem.40 plants worth is quite ugly. Matt ![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Brown Algea in my sand | Uncle Sam | Reefs | 7 | May 26th 04 04:07 AM |
Brown Algea Another Question | Uncle Sam | Reefs | 8 | May 13th 04 04:17 AM |
brown algea | news | Reefs | 8 | November 21st 03 03:39 PM |
Brown algea | kelly | Reefs | 2 | October 14th 03 01:11 AM |
Can certain gravel lead to brown algae? | Dave K. | General | 1 | August 13th 03 02:28 AM |