|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#16
September 25th 06, 05:22 PM
posted to rec.aquaria.marine.reefs
|
|||
|
|||
Built-in Overflow Problem
"Jerry Baker" wrote in message news:HgTRg.2552$422.2051@trnddc03...
Pszemol wrote: Screws underwater might look too "technical" and not pretty. Glue is more concealed. Scraping glue off of the inside of an overflow is not something I want to be doing though. Aesthetics are up to you, but silicone does not stick to the plastic as well as it does to glass, so scraping two drops off does not present too much of a challenge. If you like screws - go for it... I have seen white nylon screws, but black ones are less common so I did not even mentioned screw solution before for that reason. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| overflow box problems | jamgabby | Tech | 2 | December 13th 04 05:19 PM |
| Overflow choices | Chris | Reefs | 5 | February 9th 04 01:44 AM |
| Livebearer problem | JHudson | General | 6 | December 10th 03 07:14 PM |
| Eheim Ecco Problem - Need Urgent Help! | Kristen | Marketplace | 0 | October 27th 03 08:56 PM |
| Eheim Ecco Problem - Need Urgent Help! | Kristen | General | 0 | October 27th 03 08:56 PM |
Threaded Mode