|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 7th 06, 05:33 PM
posted to rec.aquaria.marine.reefs
|
|||
|
|||
Sarcopython Propagation Help
You can cut them however you want, but the lowest risks
will be cutting the smaller branches. You can practice on the some smaller branches, and then go for the big one. Wayne Sallee Wayne's Pets TheRock wrote on 9/5/2006 8:57 PM: Come on ! Nobody wants to touch this question with a ten foot pole ?!?! "TheRock" wrote in message news:vxYKg.15795$242.14333@trndny06... It's time for me to propagate my Sarcopython. It's huge. All sites I have visited to propagate say to cut off the cap, cut it into sections and glue it to plugs or small pieces of rock. Because it's about 10" high I was wondering if I can cut it closer to the base. Does it need to be cut close to the top ? TIA, Chris 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Coral propagation | TheRock | Reefs | 5 | February 26th 06 07:39 AM |
| baby tears propagation | Zathoros | Plants | 4 | January 21st 06 04:10 PM |
| Water Sprite Propagation | Brian S. | Plants | 3 | October 21st 04 08:05 PM |
| Plant Propagation | Joseph | Plants | 2 | December 20th 03 05:12 AM |
| Lilly Propagation | Ted | General | 4 | September 16th 03 01:42 AM |
Hybrid Mode
