![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
ONJ wrote:
Well I guess my question is, do I run it so that the bubbling water is at the bottom of the collection cup tube and it will foam up to the top later? Yep - that's about right. The water actually should be between 1/4" and 1" below the bottom of the tube. George Patterson If you torture the data long enough, eventually it will confess to anything. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Great experience with Petsolutions... Time and time again. | [email protected] | General | 0 | September 12th 06 08:50 PM |
Skimmer Question: Which skimmer to purchase?? | Steve Shapson | General | 0 | July 28th 04 04:38 AM |
Skimmer Question: Which skimmer to purchase?? | Steve Shapson | General (alternative) | 2 | July 28th 04 04:38 AM |
"In line" skimmer vs "In sump" Skimmer | Steve & Gail Welter | Reefs | 0 | January 21st 04 05:30 PM |
Skimmer time | reefman MC | Reefs | 3 | January 8th 04 11:11 PM |