|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
February 25th 05, 02:41 AM
|
|||
|
|||
"bettasngoldfish" wrote in message oups.com... I have three of the penguin 330's and I really like them but the filter cartridges can get expensive. One filter takes two cartridges and also has two baskets so that you can add extra carbon. The filter intake that you were asking about is fairly long, in my bare bottom tank it only has about an inch or so clearance from the bottm of the tank. In my cichlid tank (which has gravel) I had to trim the intake tubes down a bit. Hope this helps! I have a smaller one. The only filter is the one that slides in behind the bio-wheel. You're saying this filter requires more? A 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about TETRA PRF 1500-2500 pressure filter. | steve | General | 4 | June 7th 04 12:22 PM |
| Pool Sand Filter Help!! Green Water!! High Electricity!! | matt clark | General | 22 | May 10th 04 10:44 AM |
| Filter Media Question (Rainbow Lifegard setup) | sl | Cichlids | 6 | March 17th 04 11:21 PM |
| filter speed and plants question? | flupke | General | 6 | October 30th 03 01:58 PM |
| I need a very simple answer to a lighting and filter question. | Ben | General | 8 | July 26th 03 07:12 AM |
Threaded Mode