A Fishkeeping forum. FishKeepingBanter.com

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » FishKeepingBanter.com forum » ponds » General
Site Map Home Authors List Search Today's Posts Mark Forums Read Web Partners

New Pond Project



 
 
Thread Tools Display Modes
  #1  
Old January 19th 04, 01:11 AM
matt wright
external usenet poster
 
Posts: n/a
Default New Pond Project

I would welcome any advice. I am building a pond for the first time, i
is a large pond approx 60 feet by 30 feet and about 6 feet deep in th
middle. It has been excavated and now I aim to put a layer of "Teram
geotextile (bit like weedblock fabric) followed by about 1 inch of san
and then I aim to put down "silage sheet", this is the plastic farmer
use to line silage and slurry pits and comes in very large sizes. It i
much cheaper than official pond liners. Then I intend to cover th
sheet with another layer of geotextile and then sand with patches o
gravel for cosmetic effect. It will be trickle filled via a small pum
from a stream which comes off the mountains. Questions: anyone els
used silage sheet? I'm pretty certain the sheet is UV stable but woul
welcome comments and any advice
-
matt wrigh
-----------------------------------------------------------------------
posted via www.GardenBanter.co.uk

  #2  
Old January 21st 04, 02:43 AM
Ted
external usenet poster
 
Posts: n/a
Default New Pond Project

Matt,

I used EDPM from a place that manufactures it for usage around chemical and
fuel tanks. I had no problems with it. Do you know what the material you
are looking at is made of?

"matt wright" wrote in message
s.com...
I would welcome any advice. I am building a pond for the first time, it
is a large pond approx 60 feet by 30 feet and about 6 feet deep in the
middle. It has been excavated and now I aim to put a layer of "Teram"
geotextile (bit like weedblock fabric) followed by about 1 inch of sand
and then I aim to put down "silage sheet", this is the plastic farmers
use to line silage and slurry pits and comes in very large sizes. It is
much cheaper than official pond liners. Then I intend to cover the
sheet with another layer of geotextile and then sand with patches of
gravel for cosmetic effect. It will be trickle filled via a small pump
from a stream which comes off the mountains. Questions: anyone else
used silage sheet? I'm pretty certain the sheet is UV stable but would
welcome comments and any advice?
--
matt wright
------------------------------------------------------------------------
posted via www.GardenBanter.co.uk



 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
The 'Aquascape System' has the be the WORST pond system outthere Glenn General 11 November 17th 03 10:58 PM
Green Farm Pond Dave General 4 August 23rd 03 03:07 PM
question on my pond RichToyBox General 17 August 1st 03 12:35 AM
How is your 2003 pond project going??? Chad General 6 July 28th 03 05:42 PM


All times are GMT +1. The time now is 04:59 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 FishKeepingBanter.com.
The comments are property of their posters.