|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 21st 05, 06:34 PM
|
|||
|
|||
Pinpoint Ph Controller Q
Does anyone know if the probe on a Pinpoint Ph Controller is totally
submersible, or is it necessary to keep the top part (where the wire exits the unit) dry ??? Thanks for any help. Henry 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| handheld pH meter to replace PinPoint? | Dave | Reefs | 8 | October 28th 03 05:25 PM |
| Good Deal on Pinpoint pH Controller | Arnim | Plants | 5 | September 28th 03 11:51 PM |
| How to measure effluent of Ca Reactor with Ph Controller | MarkW | Reefs | 5 | September 17th 03 12:45 AM |
| How to measure ph of Ca Reactor with ph controller | MarkW | General | 0 | September 15th 03 08:21 PM |
| What lighting controller and tubes from this site... | Marcus Fox | Plants | 0 | August 2nd 03 06:56 PM |
Threaded Mode