![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I have a small pond that is doing quite well. I have a beckett 350 gph
pump that has been going nonstop for 2 years and is now beginning to fail (it just stops running). This is a submersible. it runs h20 through a biological sand filter, and a UV filter. It may be a bit strong for its use, a 250 might work just as well. What manufacturer would you recommend as a replacement, and who would you buy from? Carl -- -- http://www.cobaltbluefilms.com |
#2
|
|||
|
|||
![]()
I have the same pump that is going on its 3rd year and I run it through
frozen winters. I would check for debris build up as this would explain the intermittent faults. If a pump has fried it will stop working all together ... not on and off. Carl Beyer wrote: I have a small pond that is doing quite well. I have a beckett 350 gph pump that has been going nonstop for 2 years and is now beginning to fail (it just stops running). This is a submersible. it runs h20 through a biological sand filter, and a UV filter. It may be a bit strong for its use, a 250 might work just as well. What manufacturer would you recommend as a replacement, and who would you buy from? Carl |
#3
|
|||
|
|||
![]()
Do what the Canadian Cowboy suggested first.........If I was looking
to buy a pump I would be looking for a Danner Pond MAster pump, of the same size or bigger if the price was right. You can always install a ball valve on the outlet and throttle its GPH down to what you need. Danners are very energy eficient and are seal less drive as well. Most can be run in or out of the water if the need arises. On Mon, 04 Apr 2005 09:42:49 -0700, Carl Beyer wrote: ===I have a small pond that is doing quite well. I have a beckett 350 gph ===pump that has been going nonstop for 2 years and is now beginning to ===fail (it just stops running). This is a submersible. it runs h20 ===through a biological sand filter, and a UV filter. It may be a bit ===strong for its use, a 250 might work just as well. === ===What manufacturer would you recommend as a replacement, and who would ===you buy from? === ===Carl ============================================== Put some color in your cheeks...garden naked! |
#4
|
|||
|
|||
![]()
I have a 1200 gph little giant in a preformed 220 gal pond with a small
upper pond and water fall . The fish are doing great they like the water moving and swim in the fast water a lot and when summer arrives and we fill the upper pond with plants turning the water over that fast it is clear . This pumps runs steady , in winter I put a elbow on the pump disconnect the waterfall and let the water circulate with a floating heater . this pump has run for 4 years non stop $ 150.00 can "Carl Beyer" wrote in message ... I have a small pond that is doing quite well. I have a beckett 350 gph pump that has been going nonstop for 2 years and is now beginning to fail (it just stops running). This is a submersible. it runs h20 through a biological sand filter, and a UV filter. It may be a bit strong for its use, a 250 might work just as well. What manufacturer would you recommend as a replacement, and who would you buy from? Carl -- -- http://www.cobaltbluefilms.com |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
What size pump??? | GoldLexus | General | 3 | June 16th 04 05:30 PM |
aeration | Newbie Bill | General | 30 | June 12th 04 02:11 AM |
Pump/filtering the basics??????? | The~Doofie~Man© | General | 9 | May 20th 04 10:04 PM |
Filtration | Destroyallx | General (alternative) | 3 | May 15th 04 08:47 AM |
Which Pump is Right for my Pond?? | Steve Shapson | General (alternative) | 2 | April 19th 04 04:28 PM |