|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 3rd 03, 02:57 PM
|
|||
|
|||
Pre Heat Bulb on an Electronic Ballast?
What would happen if I were to use the Pre Heating bulbs (slow starting) on
and electronic ballast? (Instant or rapid start) It would prolly just shorten the life of the bulb I would imagine... Oh, the bulbs would be overdriven as well BTW. The reason for me asking is the only "industrial" 36" T8 6500K bulb that I can find is from Grainger but it is the pre heating kind. =\ TIA ~Mort 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CF bulb failure mode? | Jeff Dantzler | Tech | 2 | August 10th 03 12:33 AM |
Threaded Mode