![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I have rather hard water, and I have a conductivity meter that is
calibrated to indicate PPM to measure it. I noticed all the smart people specify measurements in microseimens, so I got a meter calibrated to read that way. Off scale high! So much for measuring that. |
#2
|
|||
|
|||
![]()
Charles wrote:
I have rather hard water, and I have a conductivity meter that is calibrated to indicate PPM to measure it. I noticed all the smart people specify measurements in microseimens, so I got a meter calibrated to read that way. Off scale high! So much for measuring that. You could dilute with distilled water before measurement, say 9 parts distilled to 1 part tap for a 10X decrease in sensitivity. The last time I bought distilled water and measured it it was 1 microseimen, perhaps your test sample is closer to 1000, so the measurement would be accurate, if not convenient. George -- |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
HAVE YOU HEARD THE GOOD NEWS! | [email protected] | Reefs | 4 | January 30th 05 07:01 AM |
HAVE YOU HEARD THE GOOD NEWS! | [email protected] | General | 15 | January 29th 05 02:30 AM |
I HAVE GOOD NEWS! ......... | [email protected] | General | 2 | January 25th 05 09:25 AM |
Pond is Looking Good But!!! | Rick | General (alternative) | 2 | July 23rd 04 01:10 AM |
Pond is looking good but! | Rick | General | 8 | July 22nd 04 04:24 AM |