![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Good morning,
Sorry if these questions have been asked before, Ive had a look through group this morning but thought I would just go ahead and ask a few questions anyhow. I bought (maybe a little to hastily) a barrel pond yesterday very similiar to the one he http:http://www.taylorsgardenbuildings.co...116&MMCF_Eshop Im unsure as to whether or not to use a liner or just fill it up, the later may take a bit longer as the wood is a quite dry so Im guessing if I keep topping it up it will naturally plug the gaps. Is one more preferable over the other if I want to add a few fish and are there any particular plants I should be looking to add? Im sure these questions have been asked many times before so sorry If I am askign them again, I should have probably looked into things before going out and buying one. Any help will be grealty appreciated. Jason |
#2
|
|||
|
|||
![]()
It's probably best to line - I would. It's apparently not good practice to
have fish and wood in the same pond (however small), same goes for metals. Make sure if there are fish in there that it is over eighteen inches deep and tyhat there ios some form of oxygenation - canadian pond weed or a minature fountain/waterfall. Nick www.pennix.co.uk wrote in message ups.com... Good morning, Sorry if these questions have been asked before, Ive had a look through group this morning but thought I would just go ahead and ask a few questions anyhow. I bought (maybe a little to hastily) a barrel pond yesterday very similiar to the one he http:http://www.taylorsgardenbuildings.co...hp?productid=1 9116&MMCF_Eshop Im unsure as to whether or not to use a liner or just fill it up, the later may take a bit longer as the wood is a quite dry so Im guessing if I keep topping it up it will naturally plug the gaps. Is one more preferable over the other if I want to add a few fish and are there any particular plants I should be looking to add? Im sure these questions have been asked many times before so sorry If I am askign them again, I should have probably looked into things before going out and buying one. Any help will be grealty appreciated. Jason |
#3
|
|||
|
|||
![]()
Many thanks for the reply Nick. I picked up a liner and have looked at
a few sites regarding fitting it but what I'm not sure is, how do I secure it in place or do I just put the liner in and fill it up? if I sound like a complete amature, it's because I am ![]() Jason Nick Byford wrote: It's probably best to line - I would. It's apparently not good practice to have fish and wood in the same pond (however small), same goes for metals. Make sure if there are fish in there that it is over eighteen inches deep and tyhat there ios some form of oxygenation - canadian pond weed or a minature fountain/waterfall. Nick www.pennix.co.uk |
#4
|
|||
|
|||
![]()
Ususally, the pressure of the water will hold the liner in place.
Firstly check inside the hole/vessel to ensure there are no spiky bits that are likely to be able to poke through the liner. If in doubt, remove, don't be complacent or lazy, or you'll have to replace the liner (boring, time consuming and expensive). Once you are happy with the inside of your hole/vessel being smooth and poky-bit free, insert the liner. Depending upon the hole or vessel you are putting it into, the water will hold up the liner. If you put the liner into the vessel, then add the water, once you have the water level to the height you want, then you can trim the liner to just above that (literally just) Hope this answers the question. I can't do it for you, or if I did, it would cost an arm and a leg. Nick www.pennix.co.uk "JasonDM" wrote in message ups.com... Many thanks for the reply Nick. I picked up a liner and have looked at a few sites regarding fitting it but what I'm not sure is, how do I secure it in place or do I just put the liner in and fill it up? if I sound like a complete amature, it's because I am ![]() Jason Nick Byford wrote: It's probably best to line - I would. It's apparently not good practice to have fish and wood in the same pond (however small), same goes for metals. Make sure if there are fish in there that it is over eighteen inches deep and tyhat there ios some form of oxygenation - canadian pond weed or a minature fountain/waterfall. Nick www.pennix.co.uk |
#5
|
|||
|
|||
![]()
Many thanks for all your help Nick it is much appreciated. I have
prepared for the liner and smoothed it all already, now when it stops raining I'll get out and finish off the job. I would'nt be able to offer an arm or a leg anyhows I've already had to use those to pay for returfing the lawn and putting the patio down ![]() Many thanks Jason Nick Byford wrote: Ususally, the pressure of the water will hold the liner in place. Firstly check inside the hole/vessel to ensure there are no spiky bits that are likely to be able to poke through the liner. If in doubt, remove, don't be complacent or lazy, or you'll have to replace the liner (boring, time consuming and expensive). Once you are happy with the inside of your hole/vessel being smooth and poky-bit free, insert the liner. Depending upon the hole or vessel you are putting it into, the water will hold up the liner. If you put the liner into the vessel, then add the water, once you have the water level to the height you want, then you can trim the liner to just above that (literally just) Hope this answers the question. I can't do it for you, or if I did, it would cost an arm and a leg. Nick www.pennix.co.uk "JasonDM" wrote in message ups.com... Many thanks for the reply Nick. I picked up a liner and have looked at a few sites regarding fitting it but what I'm not sure is, how do I secure it in place or do I just put the liner in and fill it up? if I sound like a complete amature, it's because I am ![]() Jason Nick Byford wrote: It's probably best to line - I would. It's apparently not good practice to have fish and wood in the same pond (however small), same goes for metals. Make sure if there are fish in there that it is over eighteen inches deep and tyhat there ios some form of oxygenation - canadian pond weed or a minature fountain/waterfall. Nick www.pennix.co.uk |
#6
|
|||
|
|||
![]()
Pretty armless then?
Sorry! Nick www.pennix.co.uk "JasonDM" wrote in message oups.com... Many thanks for all your help Nick it is much appreciated. I have prepared for the liner and smoothed it all already, now when it stops raining I'll get out and finish off the job. I would'nt be able to offer an arm or a leg anyhows I've already had to use those to pay for returfing the lawn and putting the patio down ![]() Many thanks Jason Nick Byford wrote: Ususally, the pressure of the water will hold the liner in place. Firstly check inside the hole/vessel to ensure there are no spiky bits that are likely to be able to poke through the liner. If in doubt, remove, don't be complacent or lazy, or you'll have to replace the liner (boring, time consuming and expensive). Once you are happy with the inside of your hole/vessel being smooth and poky-bit free, insert the liner. Depending upon the hole or vessel you are putting it into, the water will hold up the liner. If you put the liner into the vessel, then add the water, once you have the water level to the height you want, then you can trim the liner to just above that (literally just) Hope this answers the question. I can't do it for you, or if I did, it would cost an arm and a leg. Nick www.pennix.co.uk "JasonDM" wrote in message ups.com... Many thanks for the reply Nick. I picked up a liner and have looked at a few sites regarding fitting it but what I'm not sure is, how do I secure it in place or do I just put the liner in and fill it up? if I sound like a complete amature, it's because I am ![]() Jason Nick Byford wrote: It's probably best to line - I would. It's apparently not good practice to have fish and wood in the same pond (however small), same goes for metals. Make sure if there are fish in there that it is over eighteen inches deep and tyhat there ios some form of oxygenation - canadian pond weed or a minature fountain/waterfall. Nick www.pennix.co.uk |
#7
|
|||
|
|||
![]()
Many acknowledgment for all your advice Nick it is abundant appreciated. I have prepared for the liner and smoothed it all already, now if it stops raining I'll get out an accomplishment off the job. I would'nt be able to offer an arm or a leg anyhows I've already had to use those to pay for returfing the backyard and putting the patio down.
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
New 50 Gallon, so confused! | [email protected] | Reefs | 1 | January 10th 06 04:16 PM |
I'm confused...again | George Burnt | Reefs | 7 | May 21st 04 12:08 PM |
confused clowns | .... | General | 1 | January 4th 04 01:33 AM |
dKH and dGh Confused | Carlos | General | 1 | December 31st 03 07:07 AM |
Confused | GrlIntrpted | Cichlids | 7 | September 11th 03 03:00 AM |