![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Does anyone have an H.O.T. filter they were going to toss
and would like to give up the "Cover Lock"? That's the piece of plastic on the top of the cover that grabs the stiff wire and holds the cover on. I lost mine! And it's not listed in the Marineland Magnum manual parts section. I'm in the Portland Oregon area. Getting back into fish/discus and finding out I have less old equipment than I thought I had! Dave |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Skimmer Conflict - Part II | Marc Levenson | Reefs | 10 | January 27th 04 11:07 PM |
Kent Marine 2 part buffer question | MakitaSalesRep | Reefs | 17 | January 2nd 04 05:54 AM |
H.O.T. Magnum as Water Polisher | EGMono | General | 8 | December 30th 03 04:35 AM |
H.O.T. Magnum Bio-Wheel Not Spinning | Jim Capaldi | General | 3 | November 23rd 03 08:42 PM |
H.O.T. Magnum - Filter Material | Bob K. | General | 0 | August 16th 03 08:36 PM |